Hellboy

The sculpt was based on Terada Katsuya illustration.

This project was completed in 2006. Sculpted in polymer clay, mold and few cast were made.

The base and the giant monster was rotocasted. 

Dimention : 17cm W x 17cm L x  32cm H

* Discontinued.



The sculpt was based on Terada illustration. 
The sculpt was based on Terada illustration. 


Test sssemble
Test sssemble

Test fit from other angle.
Test fit from other angle.

Polymer clay sculpt. The horn are made in epoxy putty.
Polymer clay sculpt. The horn are made in epoxy putty.

Test fit. 
Test fit. 

Most of the original parts put together. You can see my finger holding the wing of the flying creature.
Most of the original parts put together. You can see my finger holding the wing of the flying creature.

Lower body. 
Lower body. 

This is a huge piece, and 90% solid polymer clay build layer by layer. The monster claws were epoxy putty.
This is a huge piece, and 90% solid polymer clay build layer by layer. The monster claws were epoxy putty.